Products

PE carbon spiral reinforcing pipe material production line


Configuration polyolefin single screw extruder, extrusion with high-speed, high-speed and other characteristics.
The special detachment type mixing screw and spiral structure of the nose, reasonable channel, smooth inside and outside pipe wall.
Specially designed sizing and cooling mode: production range 50-200mm, production speed of up to 0.6-1.5 m / min








Extruder	SJ-90/30B	SJ-65/30B
Head	ф50-200	ф50-125
Sizing sink	SGZL-200	SGZL-125
Tractor	SLQ-200	SLQ-200
Winding machine	SQ-200	SQ-200



Standard design of the tube head
Spiral assignment shunt body, a large space of flows, to ensure that the melt has sufficient residence time.
Low melting temperature of the best design, pipe stress is small, smooth inner and outer surfaces.
High flexibility, suitable for all co-extruded polyolefin material can be squeezed out two-story, three different specifications to enhance use of the spiral tube.
Optimize the design of the spiral copper sizing sleeve, its entrance with a pre-cooling device and powerful vacuum suction device, applied to the pipe, high-speed extrusion.
Specially designed spray head brings efficient cooling spray.
Vertical movement motor regulation, and down about three-dimensional adjustment can be achieved.
Box made ​​of stainless steel.
High-efficiency water pump and a special spray head to bring efficient cooling spray.

On a：PVC threading pipe extruding production line     Next：Pre-stress plastic corrugated pipe